View Poll Results: How much WHP is your car making?
200-300WHP
9
3.88%
300-350WHP
60
25.86%
350-400WHP
41
17.67%
400-450WHP
47
20.26%
450-500WHP
28
12.07%
500-550WHP
13
5.60%
550-600WHP
6
2.59%
600+WHP
28
12.07%
Voters: 232. You may not vote on this poll
How much WHP does your car have?
#41
444.99/417.87 thru a Yank PT4000,4L60E and a 12 bolt Moser with 4.11 gears. Best time so far 11.28@119mph. I've added lower A-arm relocation brackets and a new set of 28"MTDRs since then but I haven't ran it at the track yet with the new setup. I was hiting OD before when I ran the 11.28@119 so I should loose a little in the 1/8th and pickup a little in the 1/4. We will see!
#44
I'm about 360/360 or so.
A while ago I got a dyno tune done by Cunningham Motorsports and put down 344whp and 351 ft/lbs. Since then I've added the Fast Toys Ram Air and an aluminum driveshaft (and also 3.42 rear diff) and my butt dyno read at least 15whp increase. So, I feel about 15whp increase is safe
Mods are in my signature.
A while ago I got a dyno tune done by Cunningham Motorsports and put down 344whp and 351 ft/lbs. Since then I've added the Fast Toys Ram Air and an aluminum driveshaft (and also 3.42 rear diff) and my butt dyno read at least 15whp increase. So, I feel about 15whp increase is safe
Mods are in my signature.
#45
378/360 Stock heads, comp springs, hardened pushrods, TF228/232 cam, ls6 intake, stock throttle body, LT's, and dumped dual exhaust.
Heads are getting Port & Polished and going with a Fast 90/90. hoping to break 410hp/380tq with the new setup.
Heads are getting Port & Polished and going with a Fast 90/90. hoping to break 410hp/380tq with the new setup.
#48
Made 574whp on 10lbs threw a 400 and 3800 unlocked stall with a 9inch out back. Now on 13lbs with more timing and e85.
So I'm assuming I'm in the 600whp+ club.
Still slow as ***!
So I'm assuming I'm in the 600whp+ club.
Still slow as ***!
#58
ms3 cam with ported 5.3 heads, pacesetter LT's to a single 4" exhaust, ls6 intake, ported TB, SLP high volume oil pump, yella terra rockers, built 4l60e with a 3800 stall and 3.42 rear end. Should be about 420-430ish I'd imagine
#59
#60
My buddies 99 Z28 A4 put down 295whp with lid and catback.
My 00' pulled 340hp/350ft-lb with
-Lid
-P&P TB
-LS6 Intake
-Headers/Catted Y
-Cat Back
-Mail Order Tune
I usually trap high 113mph with no back seat, pass. seat, spare tire/jack and empty fuel tank with 159lbs driver
UD pulley and ORY would push me to over 350whp and a solid 114mph trap.