glad to help! 
Engine Temp Gauge
Engine Temp Gauge I changed 2 parts trying to fix this. One of them was this sensor thingy that goes into the driver side of the head or block. And the T-stat. It still doesnt work. Anyone have and ideas? Maybe I bought a bad part? Or maybe its something else. Thanks.
The only temp sensor that controls the gauge inside is the one on the driver side head, is the wires cut at all? The wires could just be messed up follow the wire from the DS head and down and see if the wire that clips into the DS sensor is cut, or twisted at all.
Last edited by blk97z28; Oct 18, 2007 at 05:12 PM.
Well, on the wire from the head thingy is not like cut complety but the plastic stripping is off on a small area of the wire. What ill try to do is get a picture up by this weekend. Thanks for the support.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo Which sensor did you replac the thing that goes inside the DS head? If not I would replace I would do that along with replacing the pigtail which clips into the DS sensor that goes into the head.
My bad, that is just an LT1 thing. LS1s only have one coolant sensor. According to the specs I just looked up a 98 should have a 3 wire sensor, while 99-02s should have two wire sensors. The car in the picture is a 98 but it looks like just two wires. 
I think you are on to something there. Automaticfastic, can you see where that green wire goes? Is it just hanging? Well I dont have the car with me at work. I will check that green wire when I get home. Also It use to be a V6. All I know is its a 98 or 99 engine. 853 heads. So if its a 99 and I bought a 98 part its not gonna work huh?
The green wire just sits there. I pulled it out, it doesnt go no where.... So do I need to buy a 99 part #? Also my buddy has a 98 TA and his only has 2 wires. So maybe its the 99 and up that have 3?
I have an 02 and its a two wire. you should ohm out where that green wire goes. see if you can find a diagram or schematic and trace it to the PCM or something. It has to go somewhere. maybe a previous owner did something?
