Pacesetter Lt Hitting Driver Side
Thread Starter
Staging Lane
Joined: Oct 2008
Posts: 67
Likes: 0
Pacesetter Lt Hitting Driver Side K I Know This Is Old But My Lt And Y Are Hitting Under The Driver Side Ive Put On The Mufflex Piece And It Helped For A Little Bit But Then Went Back To Banging Again Any Help Please.
CAPITALIZATION necessary?
Try banging down a little on the top side of the y-pipe where it hits the floordoard and it will go away. That is how it is on the SS and have not had any problems whatsoever!
Try banging down a little on the top side of the y-pipe where it hits the floordoard and it will go away. That is how it is on the SS and have not had any problems whatsoever!
Poly Motor Mounts is the only real way to fix this. The real problem is caused by the torquing of the motor. Putting exhaust hangers on essentially makes your exhaust system another motor mount. Go straight to the source and replace the mounts.
TECH Fanatic
Joined: Feb 2004
Posts: 1,259
Likes: 0
From: Lexington, KY
Agreed, this is the only cure I found. I tried 3 different Y pipes and spent alot of time adjusting and prying on them but it always came back until I swapped out the mounts.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
I took off the y and used blocks of wood and a floor jack to make an indention in mine. Put all the weight on the jack and it made a perfect fit, no more banging. And my BBK flange was literally wedged against the floor board, couldnt even put a peice of paper between them. Now i got about 2 inches.
