Fan switch mod write-up
The SES light does not come on b/c you are tapping into the OEM wiring for the fans. I know tha when Brian2006 did the fan mod his SES light came in, but he wired it differently, added a resistor and was good to go
so when the computer turns on the fan your light turns on? bad ***. i might do that
Teching In
Joined: Apr 2009
Posts: 5
Likes: 0
From: South Dakota
I am wondering if a person could set this up with two switchs. I was thinking that i could get two new switchs that would fit in the same place as the fog light switch and traction control switch.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Five Reasons the Camaro Was the Most Pivotal Player in the Pony Car Wars 2.0
Brett Foote
10 Reasons the LS7 Is GM's Most Extreme Naturally Aspirated V8 Engine Ever
Verdad Gallardo
excellent write-up..
Only time I get an CEL, is for some reason when I go to the track. my fans alway trip the CEL light LOL.. Dunno why
I need to put a resistor in mine.. My damn LEDs are soooooooo bright
I need to put a resistor in mine.. My damn LEDs are soooooooo bright
Very nice write-up! I am actually looking for this exact setup (DPDT) wiring for high low function on the fans. Does anybody know what the color combination refers to on the SLP fan switch (Hi/Low). There is a black ground strap that is grounded to a stud in the engine bay close to the PCM. There are 3 colors on the SLP fan switch and I'm trying to figure out what each color is for, (Hi, Low, and center off). If anyone can give me the positions on the switch I will wire the SLP wiring into a (DPDT) that is in my EMBLEM PROS switch plate and post the schematic for this switch also.
I actually just figured out the SLP wiring this morning, real easy. Here is a link to the setup.
https://ls1tech.com/forums/appearanc...an-wiring.html
https://ls1tech.com/forums/appearanc...an-wiring.html
Great write up just finished mine up.
Only problem I could not find anything even close to good for the led's. So I am wired for them and will find some when I go to a better area for stores. And I need to make a panel to cover where the astray goes.
Only problem I could not find anything even close to good for the led's. So I am wired for them and will find some when I go to a better area for stores. And I need to make a panel to cover where the astray goes.
there is nothing in this mod that will prevent a ses light. You can either use resistors to prevent pulling a full ground to the pcm, or do what SLP does in thier fan switch and tap into a hot wire with some components to prevent the pcm from seeing the full ground signal.
Ryan
Ryan
ABS plastic and a dremel is your friend. Takes no more than 20 minutes to fab one up. Do you have a Radio Shack around you? Radio Shack carries LEDs and resistors.
Teching In
Joined: Aug 2010
Posts: 35
Likes: 0
From: Grand Junction, CO
