Problems after installed the lid
12 Second Club
iTrader: (4)
Joined: Dec 2007
Posts: 1,712
Likes: 0
From: Between Bowling Green/Owensboro
Thread Starter
TECH Enthusiast
iTrader: (22)
Joined: Aug 2004
Posts: 544
Likes: 0
From: >>>_FRISCO_MUSCLE_<<<
Well, the seller said shanev8 port it and he had no problem with it. He had a camm'ed car and mine is stock that could be different story. I just don't get it why the stock tune can't handle the IAC and idle speed even I adjusted the TPS. I'll post up on HPT forum for this.
When I adjust the set screw, the blade was closed shut and still jumping the idle rpm. I don't know if the hole on the blade drilled too big.
Originally Posted by Joshiedoom
If the maf isnt the issue then the ported TB has to much metal removed around the blade area
Last edited by darknessxyz; Nov 16, 2008 at 02:22 AM.
Thread Starter
TECH Enthusiast
iTrader: (22)
Joined: Aug 2004
Posts: 544
Likes: 0
From: >>>_FRISCO_MUSCLE_<<<
No light at all. I'll try to take some pics tomorrow after I finish the long cruise. The porting actually is good, shine like a mirror also was knife edged on the outside. The butterfly plate was untouch but I can tell the hole on the plate was bigger than stock.
