tsp ory to low on drivers side help!!!!

Reply Subscribe

Thread Tools

Search this Thread

Feb 15, 2009 | 01:28 PM

shaun

Thread Starter

12 Second Club

Joined: Nov 2005

Posts: 1,847

Likes: 0

tsp ory to low on drivers side help!!!!

hey guys my tsp ory is to low on the drivers side and its bugging me.
the right side tucks up perfect but even if i put the pipe touching the bottom of the dr's side floor pan it still is to low.
what should i do?
thanks.

Feb 15, 2009 | 01:29 PM

jsteele90

11 Second Club

iTrader: (13)

Joined: Mar 2007

Posts: 2,870

Likes: 2

From: delaware

damn mine is too high. this tsp ory is junk

Feb 15, 2009 | 01:34 PM

Badguy7

TECH Addict

iTrader: (6)

Joined: May 2007

Posts: 2,242

Likes: 0

From: Odessa, TX

What size is the ory pipe?? And you've pushed the driverside all the way up against the floorboard and still seems to sit low??

Feb 15, 2009 | 01:49 PM

KevinWS6

Teching In

iTrader: (4)

Joined: Aug 2005

Posts: 38

Likes: 0

From: Lafayette, LA

I really like TSP and they have great customer service, but was never really happy with the ory. I could never get it to fit right.

Feb 15, 2009 | 02:50 PM

95 Z28

12 Second Club

iTrader: (21)

Joined: Apr 2006

Posts: 1,406

Likes: 0

From: West Seneca, NY

I had their ORY. It does hang a bit low on that side. I like the Pace one better...that doesn't help you though. Best you can do is loosen it up, shove a piece of rubber in between the pipe and floorboard, jack the pipe up (spare tire jack works great) and tighten it down. When I had the TSP one that's what I did, and I kind of just let the pavement "self clearance" the pipe

Feb 15, 2009 | 07:09 PM

shaun

Thread Starter

12 Second Club

Joined: Nov 2005

Posts: 1,847

Likes: 0

i think im eaher going to have one custom made or im going to bfh the **** out of it lmao.
i could never get it to seal no matter what type of clamps i used so i had it all welded even at the headers and i still got a leak lol so im thinking its the headers them self and its pissing me off.my ory looks lower than the car in the sig pic on top of this post.
**** on it im going to go buy a bfh now im fired up .

Feb 16, 2009 | 12:11 AM

Arc00TA

TECH Fanatic

iTrader: (17)

Joined: Apr 2007

Posts: 1,729

Likes: 1

From: The 'Nard

Use a torch, heat it, hammer it, repeat. Or bring it to an exhaust shop they can put the square fitting on their bender thing ans stamp it in like an inch, it will fit better.