transaman98

iTrader: (16)

Hey everyone I am trying to find a decent merge collector to re-do my 3" y pipe off my headers. After a little research it seems as though this offers pretty significant power gains over the the hooker 3" ORY. I checked summit, jegs, lg motorsports, and even googled the damn thing. I cant seem to find a 3" to 4" y pipe. I read the pat g writeup on 500rwhp with just heads and cam and I am thinking that I am leaving power on the table with the exhaust setup I have right now. Anyone know where to find this merge collector?

3800RS

iTrader: (15)

get the mufflex y-pipe for hooker headers

Full-Force

iTrader: (11)

flomaster merge is the best you can buy for flow

summit and jegs carry it

transaman98

iTrader: (16)

i cant seem to find it on either...perhaps someone can help?

transaman98

iTrader: (16)

nevermind i found it. I just had to search by brand instead of going through the exhaust section.

Daryn

iTrader: (19)

mufflex is over priced . get some 20$ mandrel mends and a flowmaster merge from jegs.

can all be done for under 100$

3800RS

iTrader: (15)

^^yea it is but it shows a pic and gives the idea

ramairJP

iTrader: (3)

You can get one like Pat's from Burns Stainless, but be prepared to pay a steep price for it.

w3s1c0a5t

iTrader: (3)

I built a 3/4 Y using the flowmaster collector. I went with a bullet on after that. I think the whole thing installed and all was a total of like 200 bucks.

transaman98

iTrader: (16)

so since I already have a hooker 3" ory what all would I need besides the merge collector?

w3s1c0a5t

iTrader: (3)

Nothing have the exhaust shop blend in the collector.

transaman98

iTrader: (16)

would they need the car to do that? or could it be done without the vehicle there? You think this should cost about $200-ish?

TheSilverOne

iTrader: (22)

the car would definitely have to be there

w3s1c0a5t

iTrader: (3)

200$ was for my merge muffler and them doing the rest minus the turndown and me later adding the turndown.

onslwcavi

iTrader: (9)

https://ls1tech.com/forums/generatio...-4-y-pipe.html

transaman98

iTrader: (16)

how is clearance on that?

udienow

iTrader: (18)

Most definatly go with the flowmaster merge... they have a 3" to 4" one. I went with a 3" to 3.5" then reduced back down to 3", as my cat-back is only 3". I had a local shop (FLP) add this merge to my TSP ORY for me and the reducer installed for $200 bucks. This included parts and labor cost.