In diameter. thanks

 

Well it's small, smaller than stock. Enough smaller to run the accessories 25% slower. I can measure mine if you need a "quanitative value" or you could calculate it from the stock size with 25% less circumference. diameter = circumference/pi.

 

I dont have the stock one readily available. If it isnt to much trouble could you get a measurement. I am not sure what pulley I have on my car (bought over 2 yrs ago). I was under the impression it was an SLP pulley but doing a little research today I couldnt find any SLP pulleys at any of the vendors. So now I have to resort to measuring them out to see if in fact I do have 25% underdrive. TIA

 

its hella smaller, put it that way.

 

Are they making charging problems lets say in heavy traffic?

 

Just measured my ASP pulley that I put on about 2 months ago; it has an overall diameter of 5.75 inches.

 

No, not that I've seen on this board or the old SLP board. There was one guy that had his battery go dead right after the pulley install, but his battery was a few years old. I've seen no problems so far either. I think it's one of those few mods with no downsides other than forking over the loot to buy the pulley.

 

Cal : thanks for info