Single Chambers on True Duals vs. Bullets
#21
TECH Senior Member
iTrader: (96)
Join Date: Aug 2007
Location: Turnin' Wrenches Infractions: 005
Posts: 24,241
Likes: 0
Received 81 Likes
on
72 Posts
TSPENCE, post up your outside vids of your car.
2nd gear hit at 4k
http://www.youtube.com/watch?v=DNmnWZiXXfo
Putting around the neighborhood with a Yank4k
http://www.youtube.com/watch?v=bcZGEd0AYDE
#22
TECH Enthusiast
iTrader: (5)
Join Date: Jan 2006
Location: seymour indiana
Posts: 660
Likes: 0
Received 0 Likes
on
0 Posts
I have numerous friends that have similar setups and i prefer mine still. I have a friend that has single chamber flowmasters dumped and asked me to trade him setups so like you said to each his own. I love the deep agressive sound of dumped bullets. Mine isnt raspy and has a great tone.....
shows my setup at different RPMs before the cam install
http://www.youtube.com/watch?v=5obrqHQy1qc
shows my setup at different RPMs before the cam install
http://www.youtube.com/watch?v=5obrqHQy1qc
#23
10 Second Club
iTrader: (28)
I like em both, but like the deepness of the single chambers better. The bullets have more of a "scream" if that makes sense. Here's mine (single chambers):
outside
http://www.youtube.com/watch?v=K2Vy0Suuuhg
from inside car at track (that vibrating sound is my plastic cam mount)
http://www.youtube.com/watch?v=8fdEL__qK20
outside
http://www.youtube.com/watch?v=K2Vy0Suuuhg
from inside car at track (that vibrating sound is my plastic cam mount)
http://www.youtube.com/watch?v=8fdEL__qK20
#25
TECH Addict
iTrader: (30)
This is with the old motor (bolt-on LS1). It sounds a little different than a lot of peoples' TD's because I went with an H-pipe instead of an X. I wish I would've went X. I think I'm going to go with an X pipe when I do the Super 44's though, because the H is too raspy.
http://www.youtube.com/watch?v=P035w6zpw1g
http://www.youtube.com/watch?v=bOex9OAjLeo&NR=1
http://www.youtube.com/watch?v=P035w6zpw1g
http://www.youtube.com/watch?v=bOex9OAjLeo&NR=1
#27
I had single chambers ture duals on my car. Sounded great when it was a H/C 346. Since I went to 427 and with a 23° overlap cam, I could no longer have a conversation with my son in the car without nearly yelling .
Just recently took out the BFH and installed a pair of Hooker Aerochambers at the rear bumper and it is much nicer. Still sounds mean; but slightly mellower and deeper.
Then there are the dual 3" electric cut-outs when I want to sound like an Outlaw car .
Just recently took out the BFH and installed a pair of Hooker Aerochambers at the rear bumper and it is much nicer. Still sounds mean; but slightly mellower and deeper.
Then there are the dual 3" electric cut-outs when I want to sound like an Outlaw car .
#30
10 Second Club
iTrader: (1)
Join Date: Nov 2001
Location: Boggy Creek
Posts: 1,528
Likes: 0
Received 0 Likes
on
0 Posts
You can settle for flowmasters and be like everybody else or Borla XR-1s and be different.
#31
#32
TECH Addict
iTrader: (30)
New video I made earlier, with the new motor. Switching to an Xpipe later this week, and I'll put another vid up, for differences between an H-pipe and X-pipe, with single chambers.
http://www.youtube.com/watch?v=kzVrhe0D0oU
http://www.youtube.com/watch?v=kzVrhe0D0oU
#35
TECH Fanatic
iTrader: (9)
Join Date: Dec 2004
Location: Schaumburg, IL
Posts: 1,693
Likes: 0
Received 0 Likes
on
0 Posts
I had single chambers on my car done up in 2 ways and ended up with Sweet Thunders and cats.
After my long tubes I had flowmaster 1 chambers clamped onto the headers directly no H or X as a temporary exhaust. sounded really wicked but as you can imagine crazy loud and lots of resonance inside the car because it was dumped pretty much under the seats.. lol. Vid.. http://www.fquick.com/videos/Exhaust...1_Z28_LS1/3690
When I had the cash I bought some 3" tubing and welded up a TD setup dumped at the axle with again flowmaster 1 chambers no cats. I loved the sound of them and was not as loud in the car very deep and would set off car alarms at idle. The interior resonance was still unbearable. I daily drive the car in all weather as its my only car and with a 4000 stall it was impossibly to stay out of that resonance point. Another problem I had was ground clearance. I could only get about 2" under the mufflers and they got beat up quick. I ended up selling the exhaust after a short time.
Then came the sweet thunders... First setup was a 2.5" setup no cats into short Powersticks dumped at the axle. Resonance was almost completely gone, it as not as deep but I still loved the sound and because of the small size of the mufflers I tucked it all up super tight so no more clearance issues. going over speed bumps. I have a vid of that I made...
http://www.fquick.com/videos/2_5_quo..._mufflers/6216
Then I changed it again.. this time just a change to 3" pipe off the headers with a nice gradual neck down to 2.5" after the H pipe. Sound was the same I was just after a smoother transition from 3" to 2.5". Then I got tired of the no Cats smell wafting into the car when in traffic and put some Magnaflow 3" cats on which is where I'm at now and have no inclination to change it again.
After my long tubes I had flowmaster 1 chambers clamped onto the headers directly no H or X as a temporary exhaust. sounded really wicked but as you can imagine crazy loud and lots of resonance inside the car because it was dumped pretty much under the seats.. lol. Vid.. http://www.fquick.com/videos/Exhaust...1_Z28_LS1/3690
When I had the cash I bought some 3" tubing and welded up a TD setup dumped at the axle with again flowmaster 1 chambers no cats. I loved the sound of them and was not as loud in the car very deep and would set off car alarms at idle. The interior resonance was still unbearable. I daily drive the car in all weather as its my only car and with a 4000 stall it was impossibly to stay out of that resonance point. Another problem I had was ground clearance. I could only get about 2" under the mufflers and they got beat up quick. I ended up selling the exhaust after a short time.
Then came the sweet thunders... First setup was a 2.5" setup no cats into short Powersticks dumped at the axle. Resonance was almost completely gone, it as not as deep but I still loved the sound and because of the small size of the mufflers I tucked it all up super tight so no more clearance issues. going over speed bumps. I have a vid of that I made...
http://www.fquick.com/videos/2_5_quo..._mufflers/6216
Then I changed it again.. this time just a change to 3" pipe off the headers with a nice gradual neck down to 2.5" after the H pipe. Sound was the same I was just after a smoother transition from 3" to 2.5". Then I got tired of the no Cats smell wafting into the car when in traffic and put some Magnaflow 3" cats on which is where I'm at now and have no inclination to change it again.
Last edited by sixvi6-camaro; 06-26-2010 at 10:53 AM.
#38
TECH Fanatic
iTrader: (24)
how about some Spintechs? I just installed mine in place of my bullets on my TSP TD's.
pass with Spintech Super Pro streets
http://www.youtube.com/watch?v=n7tIS...eature=channel
pass with bullets
http://www.youtube.com/watch?v=1cZ_6...eature=channel
I love the spintechs.
pass with Spintech Super Pro streets
http://www.youtube.com/watch?v=n7tIS...eature=channel
pass with bullets
http://www.youtube.com/watch?v=1cZ_6...eature=channel
I love the spintechs.