Silicone Reducer Question
Silicone Reducer Question I recently installed a 92mm FAST intake manifold and throttle body. I also have a 85mm MAF. I don't like the looks of the SLP smooth bellow and have looked every where I know trying to find a reducer to connect my TB and MAF. I located two different websites with a 30 degree redcuer only to find out they are out of stock and won't be getting any more.
I don't want to do the Home Depot option so I was wanting to see if anyone knows where I could find a reducer (4.0" to 3.5") or had any other suggestions. I can find reducers with no angle, but I am concerned the TB and MAF won't be flush with the reducer without the angle.
Thank you in advance.
I don't want to do the Home Depot option so I was wanting to see if anyone knows where I could find a reducer (4.0" to 3.5") or had any other suggestions. I can find reducers with no angle, but I am concerned the TB and MAF won't be flush with the reducer without the angle.
Thank you in advance.
Thanks for the link. I've been searching for hours trying to find a 30 degree reducer and the only one I found is out of stock. Do you think a 45 degree reducer would be too much of an angle?
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo This is exactly what I am looking for, but they are out of stock and won't be getting any more.
http://www.hosetechniques.com/index....oducts_id=1476
http://www.hosetechniques.com/index....oducts_id=1476
Just a tip if you wanna just buy a 4" connector, go to home depot and grab the 3.5" rubber hose for PVC, cut it to slide over the maf then slide your 4" connector over that and clamp it down. youll never know its there and itll seal up just fine. Opens up your options a bit more.
