FAST 102 or FAST 92 346/LS6 engine
#25
TECH Senior Member
iTrader: (96)
Join Date: Aug 2007
Location: Turnin' Wrenches Infractions: 005
Posts: 24,241
Likes: 0
Received 81 Likes
on
72 Posts
No, sorry. Try again.
#31
TECH Fanatic
iTrader: (45)
i have pulled/installed my fast 102 a couple of times now, and if you find installing the intake a difficult job, you probably should not work on your car. a little more patience, yes. since the intake is taller you have less room to work with around the cowl. hardest part is putting some zip ties around the rear 2 bolts on both sides of the intake to hold them up in place when installing. all described in the instructions when you get the intake.
#32
On The Tree
iTrader: (1)
Join Date: Apr 2010
Location: OK / Hawaii
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
i have pulled/installed my fast 102 a couple of times now, and if you find installing the intake a difficult job, you probably should not work on your car. a little more patience, yes. since the intake is taller you have less room to work with around the cowl. hardest part is putting some zip ties around the rear 2 bolts on both sides of the intake to hold them up in place when installing. all described in the instructions when you get the intake.
#33
Turd Gen Guy
iTrader: (63)
Just anyones fyi.... You cannot use a nick williams 92mm throttlebody on the fast 102 intake and it seal properly... Use the fast 92mm tb or if u have a dbw use the ls2/3 throttlebody... And they make a product called the vmax ring for a 92mm throttlebody install on a fast 102.. It goes behind the throttlebody
#34
Just anyones fyi.... You cannot use a nick williams 92mm throttlebody on the fast 102 intake and it seal properly... Use the fast 92mm tb or if u have a dbw use the ls2/3 throttlebody... And they make a product called the vmax ring for a 92mm throttlebody install on a fast 102.. It goes behind the throttlebody