TSP LT's, ORY to borla adjustable
Thread Starter
Joined: Oct 2004
Posts: 5,121
Likes: 74
From: somewhere in TX
TSP LT's, ORY to borla adjustable Are the TSP LT's and ORY a direct connection to a borla adjustable catback or are there other parts needed for proper connection.
Trying to cover all the bases before the motor swap starts and all the goodies go in.
Trying to cover all the bases before the motor swap starts and all the goodies go in.
Prepare to do a little fab work on the y-pipe to make it connect to the I pipe. **** is not straight. I have this exact combo, was a complete pain but nice combo when said and done. Just prepare to be pissed off in the process...
TECH Apprentice
Joined: Sep 2011
Posts: 344
Likes: 1
From: La Porte, TX
When I had mine, I just left the plate completely out... It sounded amazing.
Trending Topics
Here's how it will sound, my car is the firehawk. But I have a cam and the dmh borla specific cutout and in this video its wide open.... its an idea of how loud it will be
I had to modify the driverside of the ypipe where it connected to the header.
I had to modify the driverside of the ypipe where it connected to the header.
Last edited by Slowbird780; Nov 13, 2013 at 12:28 AM.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
The best way to get everything to line up easier is to loosen the bolts at the manifold flange quite a bit. From there you can put everything on and adjust it to where you need it. Then tighten the manifold bolts back down to sink everything up. Doing it this way allows a lot of maneuverability with the system and makes the instal a much easier task.
Lonnie
Lonnie
The best way to get everything to line up easier is to loosen the bolts at the manifold flange quite a bit. From there you can put everything on and adjust it to where you need it. Then tighten the manifold bolts back down to sink everything up. Doing it this way allows a lot of maneuverability with the system and makes the instal a much easier task.
Lonnie
Lonnie
Thread Starter
Joined: Oct 2004
Posts: 5,121
Likes: 74
From: somewhere in TX
Haven't ordered my headers yet but going to get them this week.
The above tidbit of info may be good to put in the installation instructions. If it works that much easier which I don't doubt it could really save your company a blackeye on product fitment complaints that are always posted.
The above tidbit of info may be good to put in the installation instructions. If it works that much easier which I don't doubt it could really save your company a blackeye on product fitment complaints that are always posted.