Cut-out????
Thread Starter
Launching!
Joined: Oct 2003
Posts: 222
Likes: 0
From: Rockport,IN
Cut-out???? Ok i know that the cutout goes in the i-pipe but i was wondering if i should put it closer to the y-pipe or closer to the catback or just in the middle....Let me know which of these would be better, or if there is even a better place for it......Thanks
!LS1 11 Second Club
Joined: Apr 2003
Posts: 7,133
Likes: 2
From: Miami
There's actually a little pocket right under the passenger side seats that's a bit further up the I-pipe (than shown above) that's a sweet niche for a cutout. Most people place it there.
It's a simple cut-in-two places (remove segment of I-pipe), replace segment with the cutout, weld.
It's a simple cut-in-two places (remove segment of I-pipe), replace segment with the cutout, weld.
The closer in you put it, the more 3" pipe you bypass.
Dunno how much it matters. You could also do a pair
of 2.5s before the merge and maybe pick up another
HP. But I did mine at the axle turn-up out back.
Dunno how much it matters. You could also do a pair
of 2.5s before the merge and maybe pick up another
HP. But I did mine at the axle turn-up out back.
On The Tree
Joined: May 2004
Posts: 134
Likes: 0
From: Birmingham, AL
Where to put cutouts
Originally Posted by Z28Venom
Place it right where the pipe starts to bend and go up over the axle. There's a little spot there that seems to be just for cutouts..
