im-not-guilty

iTrader: (4)

Just installed a set of sop long tubes and wires rest on header tubes
Is their a different wire I should use or a shorter plug ??

1995_maro_z

iTrader: (1)

I use MSD wires.

IDriveChevy

iTrader: (5)

I also use MSD with no issue. Buy some heat shields if you are worried about them touching

Chris Paveglio

iTrader: (2)

MSD. But you might have to bend the boot just a bit so they aren't touching. I did and that's all it needed to have enough room.

dr_whigham

iTrader: (49)

Bingo! Did it on too many cars to count. Pop it on the plug, then bend it where you need it so it's not touching.

Oh.... die-electric grease... Make friends with it.

joecar

This ^ ^ MSD Superconductor wires (bendable boots) and dielectric grease.

im-not-guilty

iTrader: (4)

I had some wires from a 2012 Yukon I got to fit ok ...
Their 90's after the boot but I have 2 that just touch the tube on the drivers side..
Kinda could use 2 with 45 degree boots

ICRAZY6

iTrader: (68)

I purchased a set of Granatelli Motorsports Hi-temp Silicone Jacketing and black fire sleeves and they fit like a charm. The fire sleeves are extra protection against the heat of the headers just in case they touch. Could always buy the sleeves separate and run what ever wires you want.