Professional products 96mm intake
Thread Starter
TECH Regular
Joined: Feb 2017
Posts: 436
Likes: 29
From: Michigan
Professional products 96mm intake I was scrolling threw the intakes at the ws6 store and this intake peaked my interest for the price claims to make 17.7 more hp at 6200rpm and also making more power at lower and mid range rpm, anyone run this intake or see some dyno graphs on it? At 480$ its cheaper than what some people are selling LS6 intakes for
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Yes the Dorman fell short of oem in that test ,but that was out of the box I believe a full ported Dorman LS6 would have bested the oem. The LS2D has shown even better results . It appears to be the best bang for buck if you want to go 92 mm.
Thread Starter
TECH Regular
Joined: Feb 2017
Posts: 436
Likes: 29
From: Michigan
I have considered the bbk at 500$ its not too bad and in the dyno shoot out hotrod did of the 20 intake shootout it gave 33hp and 21tq gain over the ls1 while also 11hp and 6tq over the ls6 so if an ls6 can be had for a cheaper price it would be way worth it to get the ls6 and put some money into it, i seen some port the throttle body opening to 90mm? And then the trailblazer ss intake threw down the most hp and torque out of all the stock intakes
Last edited by tberg725; Jun 8, 2017 at 04:31 PM.
I have considered the bbk at 500$ its not too bad and in the dyno shoot out hotrod did of the 20 intake shootout it gave 33hp and 21tq gain over the ls1 while also 11hp and 6tq over the ls6 so if an ls6 can be had for a cheaper price it would be way worth it to get the ls6 and put some money into it, i seen some port the throttle body opening to 90mm?
While Im not recommending this intake , but if someone is stuborn , it may be work for the following .Someone that is not concerned with performance and weight , more show than go, its offered in polished . Its also about the cheapest intake that will accept a 102 mm tb . The Speedmaster Qualifier is the same intake as the PP intake . PP intake is complete kit with their rails, crossover and fittings. If you want to get your own rails and such The Speedmaster sells for $ 235 , but I would not use thier gaskets that come with the intake . These intakes have a plate on the bottom that can be removeed for access to port the runners.
TECH Senior Member
Joined: Jun 2016
Posts: 22,293
Likes: 3,617
From: Central Cal.