Fast 92 disassembly
Thread Starter
Joined: Feb 2010
Posts: 6,761
Likes: 292
From: Fort Worth TX
Fast 92 disassembly I took the top shell off....but does the middle piece come off too ? I notice there are several screws holding it in.....and is the inner rope seal one piece ???
Thread Starter
Joined: Feb 2010
Posts: 6,761
Likes: 292
From: Fort Worth TX
the seal is not one piece.....and after removing the middle piece I realize I am not done porting by any means.....if I was getting paid by the hr to port......I could take a vacation
I need to find my epoxy too....thinking of deleting the center posts too
some of the ports are spot on....others are off by a hair....number 7 is really off
I need to find my epoxy too....thinking of deleting the center posts too
some of the ports are spot on....others are off by a hair....number 7 is really off
If you also end up needing to replace the gasket for the upper and lower shell, look for FAST Part # 54022. Its one long strip. You have to cut it to fit and I used some clear RTV silicone to connect and seal where the cuts were made. You should end up with a few inches of extra material when done, as they give you a little more than what is actually needed.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
