Motor Mounts
Thread Starter
Joined: Nov 2001
Posts: 3,066
Likes: 0
From: Sunny San Diego
Motor Mounts I am installing my Thunder Racing motor mounts.
Are they suppose to fit without modifications to the metal?
They don't fit in the clamshell. Did anyone have to cut the poly? Or did I get the wrong ones??
Are they suppose to fit without modifications to the metal?
They don't fit in the clamshell. Did anyone have to cut the poly? Or did I get the wrong ones??
these are the ones i got. only problems i ran into were drilling the ****** rivets out of the clamshells. once they were apart thought the mounts fit right in just like OEM.
http://ourworld.cs.com/jrp98ls1/Poly+Motor+Mounts.JPG
http://ourworld.cs.com/jrp98ls1/Poly+Motor+Mounts.JPG
Thread Starter
Joined: Nov 2001
Posts: 3,066
Likes: 0
From: Sunny San Diego
Those are the ones I have. Getting the rivet outs were a piece of cake once I switched to Cobalt drill bits. 
But mine won't just drop in. I guess I will have to grind down the poly.
But mine won't just drop in. I guess I will have to grind down the poly.
Last edited by Ed Blown Vert; Sep 7, 2005 at 10:23 PM.
Trending Topics
That is right, mine had the same interference. I used a 2x4 and stepped on it and pounded it in with the board. I was too lazy to go inside and get the soap, that would help.
Brian
Brian
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
You guys that are installing these mounts need to grease the mount good first and then put them in as good as you can by hand and then get the bolts that came with the mounts started and use the bolts to pull the insert into the clamshell.
You also need to scrape all of the old mount out of the clamshell. I use a propane torch and burn it out.
You also need to scrape all of the old mount out of the clamshell. I use a propane torch and burn it out.
Thread Starter
Joined: Nov 2001
Posts: 3,066
Likes: 0
From: Sunny San Diego
Originally Posted by SVC707
did u notice if there is a difference between the two inserts i only have one and want to make sure i have the right one for the driver side