ls6 ?
02-10-2006, 01:04 PM
#2
You don't even need those if your stockers are in good shape, they are about $70 bux from the stealership for a set of 8.
But NO, you don't need gaskets.
However, you do need new coolant plugs and a front crossover pipe from a 2001+ car though. Were you aware of this?
But NO, you don't need gaskets.
However, you do need new coolant plugs and a front crossover pipe from a 2001+ car though. Were you aware of this?
02-10-2006, 04:23 PM
#4
11 Second Club
iTrader: (34)
Join Date: Feb 2005
Location: Ft. Wayne, Indiana
Posts: 3,158
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by TheBlurLS1
You don't even need those if your stockers are in good shape, they are about $70 bux from the stealership for a set of 8.
But NO, you don't need gaskets.
However, you do need new coolant plugs and a front crossover pipe from a 2001+ car though. Were you aware of this?
But NO, you don't need gaskets.
However, you do need new coolant plugs and a front crossover pipe from a 2001+ car though. Were you aware of this?
02-12-2006, 11:37 PM
#5
Staging Lane
Join Date: Jan 2006
Location: California
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by SS1875
Good point on the coolant plugs and front crossover pipe...as far as the gaskets..FAST sell's them for $32.
I couldn't find them on their website, mind pointing me in the right direction?
02-13-2006, 02:06 AM
#7
Launching!
iTrader: (15)
Join Date: Apr 2005
Location: Newark ohio
Posts: 264
Likes: 0
Received 0 Likes
on
0 Posts
I made my own plugs and cross over. Took the stock coolant pipe cut the 2 back pieces off welded them and stuck on some rubber boot things just for good measure. Then cut the front of the piping so it was just 1 pipe running from the either side welded the hole of course. Although i haven't ran the car yet but it'll work.
I DID have a problem with the intake sitting flush on the heads though cause of those wires that sit under it that go to the middle of the valley. I had to peel off the tape that was holding a little black clip off those wires so the intake could sit right. Just an FYI i dunno if anyone else ever had this problem.
I DID have a problem with the intake sitting flush on the heads though cause of those wires that sit under it that go to the middle of the valley. I had to peel off the tape that was holding a little black clip off those wires so the intake could sit right. Just an FYI i dunno if anyone else ever had this problem.