I have the 01' "cam" sitting in the 99 TB in my garage. I used the port matched TB with my intake and swapped the "cam" out. 
TB cable problem
Thread Starter
Joined: Oct 2003
Posts: 1,164
Likes: 2
From: Frankenmuth, MI
TB cable problem Just got done putting on an LS6 intake and a Shaner S3 throttle body on a 99 SS Camaro.. everything went smooth and then went to bolt the TB up and hook up the linkage for the throttle.. and the linkage is too tight and hold the TB back instead of being closed.. everything is bolted up right and the bracket holding the throttle linkage in place is all exactly the way it was on my 2000 SS.. why would it be any different for a 99?
someone help us figure this one out.. its confusing..
Thanks
someone help us figure this one out.. its confusing..
Thanks
i had the same problem (well mine was to loose, but you can adjust either way) and this was enough for me to figure it out. good luck
Originally Posted by jimmyblue
Snap-clip adjusters on the cruise-TCS and TCS-TB runs.
You may also have slack in the pedal-TCS run which is
not adjjustable, you will either have to bend the pedal
arm or insert a spacer (up to 1" may be needed to get
it to pull full open, at the floorboard).
You may also have slack in the pedal-TCS run which is
not adjjustable, you will either have to bend the pedal
arm or insert a spacer (up to 1" may be needed to get
it to pull full open, at the floorboard).
Originally Posted by orangeapeel
The blade assembly is actually bigger. Swap the shaft and blade out of that housing and use a 99-98 one.
The 98-98's had a different "cam" for opening the throttle body. Do you still have your old one?
Thread Starter
Joined: Oct 2003
Posts: 1,164
Likes: 2
From: Frankenmuth, MI
yea thats what we figured out once we looked at it.. i had no idea that 98-99 were different.. figured with all the research i've done on tech i woulda heard that one before..
But yea how do you adjust that linkage? i was looking at it and couldn't figure it out..
If not i will just swap the "cam" off the 99TB onto the ported/polished 2000 TB.. I'm going to look at my stocker and see if i can figure out how to get it off..
Thanks guys!
But yea how do you adjust that linkage? i was looking at it and couldn't figure it out..
If not i will just swap the "cam" off the 99TB onto the ported/polished 2000 TB.. I'm going to look at my stocker and see if i can figure out how to get it off..
Thanks guys!
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
