TBB equipment
Thread Starter
TECH Regular
Joined: Jul 2002
Posts: 474
Likes: 0
From: Plymouth, Minnesota
TBB equipment what is all the equipment needed to do the TBB mod? like all the hose sizes and clamp sizes..thanx <img border="0" title="" alt="[Cool]" src="gr_images/icons/cool.gif" />
TECH Senior Member
Joined: Nov 2001
Posts: 9,246
Likes: 3
From: Troy, AL
Re: TBB equipment I just used a plastic hose connector (got it at the parts house for a matter of pennies.) I used the factory clamps. In my case there was just enough hose length to keep it off the waterpump pulley.
Re: TBB equipment On the '02s with their odd fitting setup,
the hoses are different sizes. I used a
spare piece of 1/4" stainless tubing that
happened to be bent 90 degrees already.
Of course, if you don't have boxes full
of this sort of thing that isn't so helpful.
I hacked off the casting boss on the underside
so it tucked up nice.
the hoses are different sizes. I used a
spare piece of 1/4" stainless tubing that
happened to be bent 90 degrees already.
Of course, if you don't have boxes full
of this sort of thing that isn't so helpful.
I hacked off the casting boss on the underside
so it tucked up nice.
TECH Senior Member
Joined: Nov 2001
Posts: 9,246
Likes: 3
From: Troy, AL
Re: TBB equipment I don't think you'll have problems nor will you ever notice the difference good or bad. It's a squirrel mod for sure. Sounds good in theory but it's such a small thing (not like that air moving at 300 MPH stays in the throttle body long enough to get very hot) it would be very hard to prove it's worth.
