View Poll Results: Is my throttle body ported?
Yes
14
16.87%
No
69
83.13%
Voters: 83. You may not vote on this poll
Poll: Do I have a ported stock throttle body? *PIX*
#41
TECH Veteran
iTrader: (12)
Join Date: Dec 2004
Location: Rockville, MD
Posts: 4,354
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Bo White
I dont know about everyone else but I say its stock as a Buick Century sittin in the church parking lot. Ported, not ported below:
#42
TECH Resident
iTrader: (6)
Join Date: May 2004
Location: Hendersonville,NC
Posts: 896
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by bene
Took the TB out of the car again to smooth out the blade and some imperfections in TB. I want to make it more BLING like yours.
#43
Trunion King
iTrader: (16)
Originally Posted by Crazy Man
I would use 1000 grit ist then finish it with 1200 grit it takes a while but it will bling.
I can't do much on the bottom side but there are alot of metal I can port where the two holes at. Port it to make it less angle slope?
#44
TECH Senior Member
iTrader: (10)
Join Date: Nov 2001
Location: Gainesville, Denton TX
Posts: 8,766
Likes: 0
Received 0 Likes
on
0 Posts
dont mess with the holes or much of hte area around it. you do not want extra air going in there.
look at my TB and see how much metal i took out? just a good smooth transition.
look at my TB and see how much metal i took out? just a good smooth transition.