Crankshaft Position Sensor Code

Reply Subscribe

Thread Tools

Search this Thread

Oct 19, 2006 | 06:59 PM

gojo

Thread Starter

TECH Enthusiast

iTrader: (12)

Joined: Mar 2002

Posts: 539

Likes: 0

From: w.s.n.c.

Crankshaft Position Sensor Code

P0336 Crankshaft Position Sensor A Circuit Range/Performance

I'm getting this code and the car runs like hell. It stumbles and finally stalls. I can then start it and all seems fine. But it always comes back.
The sensor has been replaced but it made no difference. Any help would be appreciated. It is frustrating.
Thanks
Joe

Oct 19, 2006 | 07:09 PM

2001NBMZ28

TECH Senior Member

Joined: Dec 2001

Posts: 5,398

Likes: 3

From: Jacksonville, FL

Not sure, but think when you replace it you're supposed to do a crank sensor "relearn" with software. Try resetting the PCM and see what happens. Sorry not much help, someone will chime in...

Oct 19, 2006 | 07:29 PM

Z28_DAD

12 Second Club

iTrader: (18)

Joined: Mar 2005

Posts: 638

Likes: 0

From: Lake Zurich IL

yes you do have to do the relearn procedure. you pretty much have to take it to a shop with the right software. it may also be the reluctor ring on the crank.

Oct 19, 2006 | 07:48 PM

gojo

Thread Starter

TECH Enthusiast

iTrader: (12)

Joined: Mar 2002

Posts: 539

Likes: 0

From: w.s.n.c.

We did a crank relearn and nothing changed. I'm hoping, bigtime, that it's not the reluctor wheel. The harness has been checked for continuity. Hoping that someone has seen some condition that seems unrelated but still throws the code.
Thanks
Joe

Oct 19, 2006 | 08:35 PM

Z28_DAD

12 Second Club

iTrader: (18)

Joined: Mar 2005

Posts: 638

Likes: 0

From: Lake Zurich IL

i had a GM truck that i put a motor in at work and the CKP had alot of metal shavings on it. i cleened it off and it ran great.
but id check the reluctor ring