fast 90/ls6 heads, port match
12-30-2006, 11:25 AM
#1
On The Tree
Thread Starter
Join Date: Sep 2004
Location: edgewater, fl
Posts: 183
Likes: 0
Received 0 Likes
on
0 Posts
fast 90/ls6 heads, port match Ok everyone knows that the fast intake has some meat that can be taken out to port match, but the problem i have (which i know is killing flow/power) is the intake runner on the ls6 head is about half the size of the port on the fast intake. So what are the best heads to mate up with the fast intake?
From a port matching stand point (eg. enough port volume to take full advantage of the fast intake). Or can i port out my ls6 heads that much more?
From a port matching stand point (eg. enough port volume to take full advantage of the fast intake). Or can i port out my ls6 heads that much more?
12-30-2006, 03:08 PM
#3
On The Tree
Thread Starter
Join Date: Sep 2004
Location: edgewater, fl
Posts: 183
Likes: 0
Received 0 Likes
on
0 Posts
sry, dont have pics, wish i did, i should have takin some. The back edge of the port lines up with the intake port but the front edge of the port on the head is inside the fast intake port by like a 1/4". I dont the ls6 heads will go out that far, but does anyone know what heads fast used for there mockup?
