QTP lt's and Kooks Y?
Thread Starter
TECH Addict
iTrader: (5)
Joined: Jan 2003
Posts: 2,298
Likes: 0
From: Fuquay-Varina, NC
QTP lt's and Kooks Y? Just wondering if that combo would work. I was planning on the Hooker Y in stainless unless the Kooks one will work. I like how it looks even better. Thanks for any input.
Thread Starter
TECH Addict
iTrader: (5)
Joined: Jan 2003
Posts: 2,298
Likes: 0
From: Fuquay-Varina, NC
Don't like it and it's aluminized. I thought I saw where someone installed Kooks with cats on QTP's. I want all stainless since I spent the jack on stainless lt's.
i modified my kooks y-pipe to work with qtp headers
https://ls1tech.com/forums/generation-iii-external-engine/682400-qtp-headers-kooks-y-pipe-spohn-solid-motor-mounts.html
since that thread i tweaked the drivers side a bit for more ground clearance
https://ls1tech.com/forums/generation-iii-external-engine/682400-qtp-headers-kooks-y-pipe-spohn-solid-motor-mounts.html
since that thread i tweaked the drivers side a bit for more ground clearance
Thread Starter
TECH Addict
iTrader: (5)
Joined: Jan 2003
Posts: 2,298
Likes: 0
From: Fuquay-Varina, NC
Dang, I was hoping for something much easier. QTP advertises "their" y fits Hooker, Pacesetter, and one other one, so I would assume the Hooker Y would be more of a slip fit affair. I hope.
