header bolts
It's probably better for you in the long run. When i did my installation i used my old ones and forgot to clean the threads out, got misthreaded, and had to Re-Tap the header. It was not fun. Although not necessary to buy them, they can't be too expensive... Just make sure you get some good ones if you do (not shitty ones that will break), and torque them to spec. After a week of driving it if you didnt use anti-seize retighten them to torque spec again, they'll shake loose from heat and vibration a little bit. Good Luck.
i thought the bolts suplied by Kooks were junk compared to the stock bolts. I compared the two and it clearly looked like the factory bolts were stronger. rule of thumb : if it doesnt thred in by hand dont put a wrench on it.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
