Can I get 400rwhp out of a cam and bolt on 6.0?
#21
Hmm, that's not bad. I could go quite a bit bigger with those springs. I should probably stick to the XE-R lobes or smaller though, right? Most guys seem to run the Xtreme duals with the XFI or LSK lobes.
#22
I guarantee you (or your buddy) is going to wish they went with a tad larger cam in that 6.0 .
Im in the process of doing a cam in my LQ4 as we speak. Im piecing together the parts right now. No way, no how, I would run a 224 in the 6.0 . It is up to you guys obviously, and your wallets. But it seems like a waste of time to put a small cam in that 6.0, depending on what you want out of it. Im looking at the MS3, or a custom grind in that range. But with full exhaust and worked 5.3 heads, I think I am able to get away with it. Good luck with your build.
Im in the process of doing a cam in my LQ4 as we speak. Im piecing together the parts right now. No way, no how, I would run a 224 in the 6.0 . It is up to you guys obviously, and your wallets. But it seems like a waste of time to put a small cam in that 6.0, depending on what you want out of it. Im looking at the MS3, or a custom grind in that range. But with full exhaust and worked 5.3 heads, I think I am able to get away with it. Good luck with your build.
#23
I'm thinking the same thing. I went too conservative with the Gen1 383 that;s in there now and I don't want to do that again.
I'm going to go with the 918s and something like a G5X2 or similar. The car has a TH350 with a ~3500 stall so it doesn't need the low end bias of some of the smaller cams.
The car is my wife's, that's why I'm in charge of the build
I'm going to go with the 918s and something like a G5X2 or similar. The car has a TH350 with a ~3500 stall so it doesn't need the low end bias of some of the smaller cams.
The car is my wife's, that's why I'm in charge of the build