Over-rev?

Reply Subscribe

Thread Tools

Search this Thread

Jun 7, 2010 | 08:59 PM

#21

LS-1Z28

TECH Apprentice

iTrader: (6)

Joined: Jul 2007

Posts: 344

Likes: 0

Quote:

Originally Posted by LS1T56FTW

Now with those bolts, would I still have to worry about spinning a bearing at 6500ish, or would that only be a precaution for breaking/stretching a rod bolt?

I haven't seen too much on bearings being spun... a good oil pump will help out though.

I'd say with the rod bolts swapped out with the katech you should be good @ 6500 RPM. You definitely won't be breaking any rod bolts at 260,000 psi tensile strength. I have a set that I never used (I ended up just using the rod bolts that came with the eagle rods that are good for 190,000 psi tensile strength). If you're interested send me a PM.

Reply Subscribe