Help me out guys here. Im looking for a good/badass cam for my 4000 stall the car is not my DD so I can go big I know big is not always better but yeah what have you tried ohh and lookig for that 400 rwhp

 

Any one??

 

Brian Tooley stage iv

 

Thanks for your help ill look at that

 

Is this like a cam for spray?

 

Cam Motion:

C33-719 LS Hydraulic Roller Camshaft; 232'/236', .595"/.595", 114'+4'; 2,400 to 6,400 RPM

 

If you are running a stock bottom end I would look at cams with 232 duration and about 600 lift. BTR, TICK, and Texas Speed (Torquer 2 from TS for example) would be a great choice.

 

I am running a TSP 233/239 with Yank 4000 SS. Other mods are TSP headers and ory, 9 in. with 3.90 gears, and some suspension mods and I have been 11.76. So there is something to compare to. The car really rocks at idle.

 

x2. I really like cam motion cams. Can still use a single beehive with this cam too.

 

I have a 3600 and went with a SNS stage 2 from tick.. Threw down 424rwhp and that's with stock fuel pump not keeping up. Will post full dyno numbers after new pump is installed and back on dyno.. Oh and you'll love the torque with this cam across the board

 

Im running the tsp torquer v3 cam & love it w/yank pt4000 stall, hits hard off the launch spins alot gotta baby it & top end pulls pretty good, Im still needing to upgrade my intake, injectors, tb & fuel pump plus a better tune 373 gears & tires will do the trick. Cam & stall only w/exhaust i've kept up with a few low 12.2 second cars from a 30 roll to 140.