Katech CNC
#121
10 Second Club
iTrader: (26)
Im feeling the dilemma as well lol. Bought the car knowing it needednengine work. Snowballed and I'm rebuilding it completely....do I spring for the extra 500 head porting or is the money better spent elsewhere. Lol. I agree about katech though. Usually top notch stuff.
#122
TECH Senior Member
Snowballed..... where have I NOT heard that before..... lol
#123
Yep. So this very thread was let’s see how these crappy heads respond to a half *** cheap ****** rebuild ?? To here’s the engine and cam combo build up and now in the homestretch with a car/install/conversion. This will get a wheel number and if I know my buddy at all; his wife will beat the **** outta this thing at the drag strip. And she’ll prolly tell him it needs nitrous or something
#124
TECH Senior Member
Yep. So this very thread was let’s see how these crappy heads respond to a half *** cheap ****** rebuild ?? To here’s the engine and cam combo build up and now in the homestretch with a car/install/conversion. This will get a wheel number and if I know my buddy at all; his wife will beat the **** outta this thing at the drag strip. And she’ll prolly tell him it needs nitrous or something
#128
How very true. You can check back on like page three for my flow numbers as I’m just “joe-die grinder” and anyone can rely on the lapped in GM valve job to seal so my results are or will be what anyone could expect
The LS1 type stuff may now only represent 3%or less of they’re business as they’re cutting edge LT nowadays.
Pretty sure the website shows all the boxing labeling instructions once you’re ready to go. Jason was/is a really busy guy. Much like Tony Mamo; all the good ones are difficult to get a piece of.
The LS1 type stuff may now only represent 3%or less of they’re business as they’re cutting edge LT nowadays.
Pretty sure the website shows all the boxing labeling instructions once you’re ready to go. Jason was/is a really busy guy. Much like Tony Mamo; all the good ones are difficult to get a piece of.
#129
10 Second Club
iTrader: (26)
Jason responded to my email. Apparently they're going to update it in a couple weeks with more information and possibly flow numbers so we'll see what they say. I would be a pretty good candidate to work with them if they want to show numbers etc on the 243's. We'll see.
#132
TECH Regular
I just bought a set of their CNC 821 square ports and they look really nice. I will be installing them in a few weeks.
#138
TECH Senior Member
iTrader: (25)
https://ls1tech.com/forums/generatio...l#post19750473
the flow #'s are missing from this post or is it the pic in post a few after? i see that flow chart compare an ls2 head to an AI ported head.
the flow #'s are missing from this post or is it the pic in post a few after? i see that flow chart compare an ls2 head to an AI ported head.
#139
https://ls1tech.com/forums/generatio...l#post19750473
the flow #'s are missing from this post or is it the pic in post a few after? i see that flow chart compare an ls2 head to an AI ported head.
the flow #'s are missing from this post or is it the pic in post a few after? i see that flow chart compare an ls2 head to an AI ported head.