Ls1 stroker build valve train budget question summit? Jegs?
#21
Interesting that on that AFR review pic they are using stock rockers.
Summit also sells roller tip rockers. That's what I went with when I put TFS As Cast heads on my LS1. The TFS heads come with a little stiffer spring so you can use roller rockers. 430 open IIRC.
All the money I spent on this thing, why I didn't just buy the YT I don't know. Probably because they were twice, almost 3 times the cost of the Summit's.
I tried to get a hold of PAC, who TFS sources their springs from, to ask if I had enough spring for what I was doing. Well those bastards apparently don't return phone calls, messages or emails. I had to get the car back together so I used the springs that were on the heads.
Summit also sells roller tip rockers. That's what I went with when I put TFS As Cast heads on my LS1. The TFS heads come with a little stiffer spring so you can use roller rockers. 430 open IIRC.
All the money I spent on this thing, why I didn't just buy the YT I don't know. Probably because they were twice, almost 3 times the cost of the Summit's.
I tried to get a hold of PAC, who TFS sources their springs from, to ask if I had enough spring for what I was doing. Well those bastards apparently don't return phone calls, messages or emails. I had to get the car back together so I used the springs that were on the heads.
The following users liked this post:
G Atsma (06-16-2022)
#22
TECH Senior Member
iTrader: (39)
The first time I called was late on a Friday and I didn't expect anyone to answer and left a VM.
The following week I sent in a contact form off the website.
I did not send a message on FB.
I did not know there was a PAC rep on here.
I had a specific questions about install height and how close I should run it to coil bind, if the springs that came on the TFS heads were stout enough to run with roller rockers and 13lbs of boost or if I needed to upgrade the springs.
I would have called on Friday, Feb. 25, 2022. I just looked at old text messages where I asked a buddy of mine who has a shop and he said to check with the spring manufacturer. The following Friday I have pictures of the heads off.
Things happen, people get busy and things fall through the cracks, I get it.
But don't call BS on me.
I have a lot better things to do than get on the internet and lie about a company.
The following users liked this post:
Che70velle (06-16-2022)
#25
ModSquad
iTrader: (6)
The following 3 users liked this post by Che70velle: