View Poll Results: What setup of a 408 would you pick?
#1- Build motor completely N/A for ever. With 11.1 comp. Shooting for 500 hp/tq
90
23.14%
#2- Build motor with blower parts and low compression so in (2 years) you could get a blower.
76
19.54%
#3- Build motor same as #1 but add some nitrious type parts and then maybe put a bootle on it.
223
57.33%
Voters: 389. You may not vote on this poll
Poll: What type of 408 would you build?
How big is the Fast toys lid? before and after modified... Yeah and TSP should have made the lid IMO..
I don't remember the measurements, but I'm guessing the lid ID was maybe 5mm smaller than the OD of the MAF. What I did was put the end of the lid in some boiling water, softened the plastic, then slid it onto the MAF and put a hose clamp on while the plastic got hard. The lid and MAF look like they were made foe each other.
I don't remember the measurements, but I'm guessing the lid ID was maybe 5mm smaller than the OD of the MAF. What I did was put the end of the lid in some boiling water, softened the plastic, then slid it onto the MAF and put a hose clamp on while the plastic got hard. The lid and MAF look like they were made foe each other.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
