LS1TECH - Camaro and Firebird Forum Discussion

Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

Spray anything on GM MLS gaskets before install?

Thread Tools
 
Search this Thread
 
Old 05-08-2006, 02:56 PM
  #1  
TECH Fanatic
Thread Starter
iTrader: (19)
 
BADFNZ's Avatar
 
Join Date: Apr 2002
Location: Dyess AFB, TX
Posts: 1,590
Likes: 0
Received 1 Like on 1 Post

Default Spray anything on GM MLS gaskets before install?
I'm going to start putting my heads on and was just wondering if I needed to put anything on the gaskets before I install them. Thanks.
BADFNZ is offline  
Reply Like
Old 05-08-2006, 03:30 PM
  #2  
777
TECH Senior Member
iTrader: (21)
 
777's Avatar
 
Join Date: Jun 2004
Location: Jacksonville, FL
Posts: 6,697
Likes: 0
Received 1 Like on 1 Post

Default
Nope, they are good as is. There was a thread in the FI section where a few high hp guys install them straight out of the box.
777 is offline  
Reply Like
Old 05-08-2006, 03:35 PM
  #3  
TECH Fanatic
Thread Starter
iTrader: (19)
 
BADFNZ's Avatar
 
Join Date: Apr 2002
Location: Dyess AFB, TX
Posts: 1,590
Likes: 0
Received 1 Like on 1 Post

Default
Awesome, thanks.
BADFNZ is offline  
Reply Like
Old 05-08-2006, 04:25 PM
  #4  
TECH Apprentice
iTrader: (18)
 
92zcamaroperson's Avatar
 
Join Date: Jan 2006
Posts: 314
Likes: 0
Received 0 Likes on 0 Posts
Default
Would felpro's need to be sprayed?
92zcamaroperson is offline  
Reply Like
Old 05-08-2006, 06:33 PM
  #5  
777
TECH Senior Member
iTrader: (21)
 
777's Avatar
 
Join Date: Jun 2004
Location: Jacksonville, FL
Posts: 6,697
Likes: 0
Received 1 Like on 1 Post

Default
No, you will be fine.
777 is offline  
Reply Like
Back to Subforum
Generation III Internal Engine
View Next Unread
Thrust bearing gone?




Advanced Search

All times are GMT -5. The time now is 05:59 PM.