TchargedLS1TA

iTrader: (9)

Im wondering if someone out there who is good at engine math can figure out the length I need. I went from .030" milled 6.0L head to stock 6.0L heads and a .051" gasket.. 7.400"s are too short. Im thinking 7.45" might be what i need

heavymetals

iTrader: (3)

Rather then taking an educated guess, why not spring for a checker?

They are less then $20.

However, a good set of calipers that measure under 8" are a bit pricey.

TchargedLS1TA

iTrader: (9)

Well Im in a rush and the pushrod length checker I have wont fit in an LS1 pushrod hole...

heavymetals

iTrader: (3)

I have seen a substitute made out of two spokes screwed into the tightener (rim nub was ground off).

Pretty skinny but it worked.