what pushrod length for trex???

Reply Subscribe

Thread Tools

Search this Thread

Jun 7, 2006 | 03:09 PM

REDWS6ROCKET

Thread Starter

TECH Regular

iTrader: (4)

Joined: Jul 2004

Posts: 471

Likes: 0

From: Blue Springs, MO

what pushrod length for trex???

pushrod length for a trex what is it. doing one for a friend and want to make sure that i hav the correct length, stock long block just a cam. i've searched but no luck, thanks guys

Jun 7, 2006 | 03:48 PM

REDWS6ROCKET

Thread Starter

TECH Regular

iTrader: (4)

Joined: Jul 2004

Posts: 471

Likes: 0

From: Blue Springs, MO

any body?

Jun 7, 2006 | 04:13 PM

02Z28

10 Second Club

iTrader: (11)

Joined: Dec 2003

Posts: 795

Likes: 0

From: Joplin, Missouri

Thunder Racing should be able to tell you.

Jun 7, 2006 | 05:26 PM

orangeapeel

ЯєŧąяĐ Єl¡m¡иąŧøя ™

iTrader: (18)

Joined: Nov 2004

Posts: 16,083

Likes: 4

From: Justin, TX

Depends on if you have milled heads or not also. I doubt it since you are running the tight clearances with that cam already in stock deck height form. The 7.400, or 7.350 should be fine depending on what the base circle of the cam is and how quiet you want your valvetrain to be.

Jun 7, 2006 | 05:50 PM

Boostaholic

TECH Addict

iTrader: (4)

Joined: Sep 2002

Posts: 2,542

Likes: 0

From: Boise, ID

7400 on my trex when i had it

Jun 7, 2006 | 06:56 PM

GuitsBoy

TECH Senior Member

iTrader: (4)

Joined: Apr 2003

Posts: 6,249

Likes: 3

From: Long Island, NY

What's the base circle? if its around 1.450 then you could use anywhere from 7.400 to 7.450. 7.450 would get you closer to stock lifter preload.

Jun 7, 2006 | 08:42 PM

SPEEDYws6

TECH Fanatic

iTrader: (9)

Joined: May 2005

Posts: 1,085

Likes: 0

From: Longview, TX

Running 7.425 here, I don't think the base cirlce was on my cam card, but I messured mine with a caliper and the base ccirle was ~.030 smaller (if I remember right) than my stock 02 cam.