Just recieved my custom pushrods from texas speed, came out very nice...
Went from:
4130 CM - 5/16", .080 wall - 7.850
To
4130 CM - 3/8" - .135 wall - 7.850
I don't think these are going to deflect .

 

sweet.how much were those?

 

I think the final bill after the lathe/machine work was ~$200.

 

you shouldnt have a problem now

 

Why the machine work?

 

I believe they are not shelf pistons, they start as 3/8" round 4130 and the ends are machined to order.

 

I dont see any pistons????

 

Phil is this for the ETP headed car? Odd length, so I am figuring its for the ETP Solid Roller setup? I have been thinking about getting the larger dia/thicker walled myself..only 8.100" length. Seem much easier to flex these long bastards ya know.

Charlie

 

I think Phil's just anxious to get the motor going again

 

Do you want me to take a pic of them?

 

Charlie,
Yeah, its for a Lunati Solid Lifter and Jesel J2K Rockers.

 

Phil,
we will be over that house at about 10:15 on Sunday morning.
I think there will be 4 of us

 

what did you use to ck req'd PR length?

 

See you guys then!

 

Jesel pushrod length checker

 

YES PLEASE!!

 

Hmm...guess I need to get off my *** and order some larger, thicker pussrods up then! Good look back. I bet mine have been bending some as well..