hole in block

Reply Subscribe

Thread Tools

Search this Thread

Jun 10, 2006 | 09:31 PM

drkbluls1

Thread Starter

Staging Lane

iTrader: (1)

Joined: Nov 2005

Posts: 96

Likes: 0

From: Maricopa, Az

hole in block

just curious, but is a 3 inch by 1 inch whole in the side of your block about an inch above the oil pan on the passenger side a bad thing?

Seriously tho, its trashed right?

Last edited by Reckless; Jun 11, 2006 at 09:26 AM.

Jun 10, 2006 | 09:38 PM

227Hawk

TECH Fanatic

iTrader: (1)

Joined: Nov 2001

Posts: 1,735

Likes: 0

From: Turlock, Ca

No just motivation for a new motor.
Hawk

Jun 10, 2006 | 09:41 PM

drkbluls1

Thread Starter

Staging Lane

iTrader: (1)

Joined: Nov 2005

Posts: 96

Likes: 0

From: Maricopa, Az

Well yea, thats the plan, just got to figure out how big I am going to go...

Was pretty cool blowing it up tho

Jun 10, 2006 | 09:43 PM

drkbluls1

Thread Starter

Staging Lane

iTrader: (1)

Joined: Nov 2005

Posts: 96

Likes: 0

From: Maricopa, Az

227 are you running a direct port set up?

Jun 11, 2006 | 12:18 AM

N4cer

10 Second Club

iTrader: (11)

Joined: Apr 2006

Posts: 2,526

Likes: 1

From: Ashland, KY

If that "whole" (as you spelled it, meaning "complete") is similar to a "hole" (as in a void that should be taken up by the aluminum of your block) then it sucks. If you mean you have a whole motor, good. It's better than a partial one.

Just teasing. That sucks man. But I'll agree it was probably a blast tearing it up.