427 Lunati ls1 kit question
08-31-2006, 11:09 PM
#22
Rear oiling on early blocks I machine the cutout to .450" depth. Then hand blend the sharp edges.
I did a block this morning. Took some photos.
First is the stock block before machining. The iron blocks all have this face. Second is machining in progress. The third is the completed modification.
Steve
I did a block this morning. Took some photos.
First is the stock block before machining. The iron blocks all have this face. Second is machining in progress. The third is the completed modification.
Steve
Originally Posted by ROCNDAV
Steve how deep did you go in, when joining the galleys? I manually did this to my block. I think I went in about .25 or as deep as it is wide.
__________________
Steve Demirjian
Race Engine Development
Oceanside, Ca.
760-630-0450
web: www.raceenginedevelopment.com/
e-mail: race-engine-development@***.net
Steve Demirjian
Race Engine Development
Oceanside, Ca.
760-630-0450
web: www.raceenginedevelopment.com/
e-mail: race-engine-development@***.net
