TR 230/224 with .035" Milled Heads?
#1
Launching!
Thread Starter
Join Date: Dec 2001
Location: Bowling Green, Kentucky
Posts: 241
Likes: 0
Received 0 Likes
on
0 Posts
TR 230/224 with .035" Milled Heads?
I have the hotcam in right now and I wanna switch cams to the TR 230/227. Will I have P/V Clearance issues with this cam and stock valved heads with .035" milled off? Anyone wanna guess what gains I should expect going from my hotcam to this? I have ran a best of 11.50@118.9 in 2800+ DA's with the hotcam, but that was with 7-8 degrees of knock and around 23 degrees of timing. I need to get that straightened out, I think it's false. Anyway anyone wanna guess what the new setup would be like?
<small>[ September 21, 2002, 07:53 AM: Message edited by: Snake Skinner ]</small>
<small>[ September 21, 2002, 07:53 AM: Message edited by: Snake Skinner ]</small>