Did a search but still confused: Main Bearing clearance??
#1
Wheels up Director
Thread Starter
iTrader: (11)
Join Date: Nov 2001
Location: Mantua, NJ
Posts: 886
Likes: 0
Received 0 Likes
on
0 Posts
Did a search but still confused: Main Bearing clearance??
Helms says .0007 to .00212 I've seen others state to go a little bigger for a hi-po rebuild. I've just did the first journal and come to a clearance of .0029
Now in the other post it was stated that you should try to get .025-.035 Seems a little too large
For the measurement I used a dial bore guage and 2-3" micrometer
Any help would be much appreciated
LAter <img border="0" title="" alt="[Big Grin]" src="gr_grin.gif" />
<small>[ October 05, 2002, 01:42 PM: Message edited by: Bob2of3 ]</small>
Now in the other post it was stated that you should try to get .025-.035 Seems a little too large
For the measurement I used a dial bore guage and 2-3" micrometer
Any help would be much appreciated
LAter <img border="0" title="" alt="[Big Grin]" src="gr_grin.gif" />
<small>[ October 05, 2002, 01:42 PM: Message edited by: Bob2of3 ]</small>
#3
Wheels up Director
Thread Starter
iTrader: (11)
Join Date: Nov 2001
Location: Mantua, NJ
Posts: 886
Likes: 0
Received 0 Likes
on
0 Posts
Re: Did a search but still confused: Main Bearing clearance??
Thank you much <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
LAter <img border="0" title="" alt="[Big Grin]" src="gr_grin.gif" />
LAter <img border="0" title="" alt="[Big Grin]" src="gr_grin.gif" />