This should be ok BUT...

243's milled to 60cc with 2.02 and 1.57

Cam is a Comp grind 228/228 588/588 114+2, I will be using stock gaskets.

I would like to make sure it will go together before they get shaved.

Thanks guys,

Chris

 

All night and nobody?

These heads are getting milled tomorrow

 

60 cc's is might be too much with aftermarket valves (unless your willing to flycut). I have 243's milled to 63cc's with the same sized valves and a TR224 on 114. It's right within tolerance. I also have .045 gaskets too. Just make sure to measure!! And be willing to flycut cause I think your right within tolerance.

 

Thank you. Its not exactly what I wanted to hear but...much appreciated

 

.020 mill on that cam with stock gasket should be fine, but always better measure.

 

Thanks Predator.

 

Let us know how it comes out! .020 like Predator said should be a good bet. Good luck.

 

Should be a week or 2 before everything is back together but I'll let you guys know how it turns out.