Where to set the gap with Diamond rings @
Thread Starter
7 Second Club
iTrader: (11)
Joined: Jul 2002
Posts: 8,758
Likes: 9
From: Port Tobacco, MD
Re: Where to set the gap with Diamond rings @ .016 & .020
.018 & .022
.020 & .024
I am running a 100 shot of nitrous and plan on going to a 150 shot in the next few months.
Phillip
.018 & .022
.020 & .024
I am running a 100 shot of nitrous and plan on going to a 150 shot in the next few months.
Phillip
Launching!
Joined: Jul 2002
Posts: 260
Likes: 6
From: Pittsburgh, PA
Re: Where to set the gap with Diamond rings @ In an above post, Fireball set his at .018/.022 with his h/c motor.
Jason99T/A said he was going to set his at .022/.026 because he's adding a TNT kit on his solid roller 346.
I'm just quoting them, might want to call Diamond.
Matt
Jason99T/A said he was going to set his at .022/.026 because he's adding a TNT kit on his solid roller 346.
I'm just quoting them, might want to call Diamond.
Matt
I can shift faster than you.
iTrader: (21)
Joined: Nov 2001
Posts: 5,133
Likes: 0
From: Baton Rouge, LA
Re: Where to set the gap with Diamond rings @ Always err on the loose side with the rings, especially with nitrous. There is very little to gain with the slightly tighter end gap, but a whole lot to loose if set up too tight.
.020"/.024 would be fine.
Jason
.020"/.024 would be fine.
Jason
Re: Where to set the gap with Diamond rings @ I emailed Chris at Diamond and he told me to use .016 for the top and .018 for the second. He said that its good for N/A and light nitrous use. Give Diamond a call. Its their stuff, they should know. 
