now this is a failed lifter
#28
11 Second Club
Join Date: Mar 2005
Location: Tallahassee,FL
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
sorry for your luck man. besides bad noise did you experience any power issues--surging/missing?? i've always been paranoid about my valvetrain noise but have been assured it was just valves/springs/rockers. and i haven't ever experienced any missing or lack of power on dyno or seat of pants. i'll be replacing lifters whenever i get to pulling my heads--which i hope doesn't come sooner rather than later from this concern.
#29
TECH Junkie
Thread Starter
iTrader: (7)
Join Date: Aug 2004
Location: Prairie de Femme, LA
Posts: 3,809
Likes: 0
Received 0 Likes
on
0 Posts
i didn't notice anything really till i started it up one afternoon and had a loud tick. i drove it a bit hoping it would go away, but it didn't. also had low oil pressue when it started ticking loud, like 20psi at idle. got home and started breakin down the engine. i think it was a cam issue, not a lifter issue that caused it tho.
prior to this i had no engine problems that i could tell
prior to this i had no engine problems that i could tell
#30
12 Second Club
iTrader: (1)
Join Date: Aug 2005
Location: Greenville, OH
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
What was this spring from? I found one just like it in my lifter tray when I pulled my heads this week. I thought it was just off of one of the valve seals. Is that what this is or is it part of the lifter?
#33
TECH Junkie
Thread Starter
iTrader: (7)
Join Date: Aug 2004
Location: Prairie de Femme, LA
Posts: 3,809
Likes: 0
Received 0 Likes
on
0 Posts
yeah, i figured i was ok since it made it 25k, but i guess not. goin to call Futral tomorrow if i get the chance. don't want another camshaft right now tho until i get my 6.0/L92 setup built, and dunno when that will be.