throttle body
throttle body my throttle body was ported and polished with the epoxy and everything by bo white when he used to do them i just put it on cause i completed my motor well i here like a hissing noise comming from it is that common or is something wrong?????
Last edited by therobman; Feb 7, 2008 at 04:08 PM.
Trending Topics
I thought something was up when I read epoxy because I have never done one with any epoxy for a customer. Ive TIGed a few were the casting was thin on the bottom and close to the throtte shaft but never any IAC opening filling epoxy or welding(except when I was testing what did what on the dyno back over 4 years ago). Do you have a pic of the TB?
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
By the pic everything looks good, shapes and all. I thinned every blade I did so the factory "honeycomb" look of the blade wouldnt be on any of mine, It would be either polished to a mirror or be a satin nondirectional finish. Then when I put a TB together I always used washers under the blade screws to more evenly distribute the clamping force of the screws. Nothing wrong with that TB though, looks good
I would be real careful with that epoxy filler piece. I just found mine inside of one of the runners of the head. It was a epoxy piece with a brass colored tube in it. Not sure what happened to the other tube because it sure isn't in the epoxy piece anymore 
Staging Lane
Joined: Jan 2008
Posts: 58
Likes: 0
Just curious, how is it supposed to flow any more air if the inner diameter of the throttle blade never got any bigger? You could actually port the whole front of it off til nothing is left and you wont change how much it flows. ??? Kind of like a funnel, no matter how big the big end is, its never going to flow more than the smaller end will allow.....just look pretty.
Just curious, how is it supposed to flow any more air if the inner diameter of the throttle blade never got any bigger? You could actually port the whole front of it off til nothing is left and you wont change how much it flows. ??? Kind of like a funnel, no matter how big the big end is, its never going to flow more than the smaller end will allow.....just look pretty.
