My idle sures when the car is running and not in gear. The gauges dont move it just sounds like the car is reving up alittle and then it stops. Im all stock and just replaced the plugs and wires. I only have 30k on my car.

 

anyone?

 

does it pull while in gear as well?
it sounds like you might have a vacuum leak.

 

I really dont notice it when Im driving. I only notice it if im at a stop light or drive thru. It only revs up a bit and then goes back to normal.

 

x2 on the vacuum leak

 

 

you might try cleaning your maf sensor

 

I will give that try.

Thanks

 

I cleaned the MAF today and the car ran fine I drove ten miles turned it off and then drove another three miles and turned it off. I went to start it again and the air bag light and the service engine light both came on and will not shut off. What do you guys/gals think it could be?


thanks

Stephen

 

what did you clean the maf with? Make sure all your Vac lines are pluged in and the hoses are not pinched or torn.

 

There is a vac line behind my passenger head light that is unhooked? Is there a diagram of the all the vac lins?

thanks

 

Anyone want to help the newb?

 

Anyone?

 

Use a thethoscope or grab a piece of 5/8 fuel line and stick it to your ear. Move around your engine bay and listen for a hisssss. Check all vac lines.

 

Is there a vac line diagram anywhere? I found a black plastic line unhooked behind the passenger head light but I cant find where it needs to be hooked up?

 

The small hose on the passenger side connects to the plastic adapter at the back of the intake and is the HVAC source vacuum line. You probably knocked it of doint wires? You will need a mirror and thin arms to reach back and plug it back in.

 

The hose down by the passenger side is your vacuum reservoir tank.

 

I traced it back and it looks like it goes back toward the intake but i dont know where it connects under the head lamp? My air bag light blinks and then the stupid service engine light comes on.

 

There is only one spot on the back of the intake where you can plug it in. It's a little hard to get with everything bolted up but it can be done just feel around a bit. should be right under the MAP sensor.

 

The intake side is hooked up. Where does the other end go?