Does anyone know if this is a nice sounding cam? Custom comp cam 232/234 .600 .605 114.
Im running a catted y pipe and automatic trans.

 

Define "nice".

 

i have the same cam on 112 lsa installed and tuned today....sounds very good, not too loud and not too quiet either! nice solid lope to it

i have my dyno vids under "new cam **dyno vid**" in this section

 

A cam that has a nice lope

 

Then I'd get the same cam but with a 111' lsa.

 

236/236 .651/.651 110+4 Is my cam. Video is in my sig. Its only revving to about 4000 rpmin the video but should pull to about 7,000. Sounds pretty nice IMO if you are wanting sound. With that 114lsa its not going to be as choppy of an idle.

 

you want a cam just for the sound?

 

I dont want the cam just for the sound but i do want it to sound badass.

 

You will definately know there something in there with that one

 

read the stickys, any cam with a low lsa will give you a lopie sound, hell lower the idle on a stock cam and it will sound lopie

 

get the MS3 112LSA.... i have the MS3 113LSA it sounds bad *** but i think the 112LSA would sound better

 

I have the MS3 on a 112, (un-tuned) and it sounds amazing when I can get it to idle(or close to)

 

that cam only has 5 degrees of overlap. Get it cut on a 112 and itll have 9 degrees of overlap. Should sounds like my old car with a 228/232 on a 110 with 10* overlap...
http://lsx.streetfire.net/search/mag...0c014aec42.htm...........
and thats through cats and cutout! sounded nice enough for me

 

that sounds good

 

My TR230 has 5 degrees of overlap and it sounds downright nasty. No way in hell you're going to convince someone it's stock, even with the SLP Dual/Dual!

 

It'll sound nastier, make power sooner and you won't have to spin as high Just a little bitchier to tune. It's pretty close to my cam but I'm on XFI/XE-R lobes with 2* advance.