Just Got My Dyno Numbers....532.6
#41
TECH Fanatic
iTrader: (6)
sick numbers man! vette dr's do some good work. i ran into a red camaro ss with vette dr's opposite the ss on the back, he didn't think he needed to juice me, but once i held him off for a matter of an 8th of a mile or so he blew past me like a bat out of hell. anything sporting their name that i've seen is just plain nasty.
#42
TECH Apprentice
Thread Starter
Join Date: Nov 2005
Location: ne ct summer,naples in the fall
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
[QUOTE=blu1;9863998]First of all what type of dyno's were all these ones over the past 8 years been on?
superflow 840 with eddy current used by Tony's Corvettes-md
dynojet at Peter Farrel Supercars-va
lingenfelter- dynojet 248
superflow 840 with eddy current used by Tony's Corvettes-md
dynojet at Peter Farrel Supercars-va
lingenfelter- dynojet 248
#43
TECH Apprentice
Thread Starter
Join Date: Nov 2005
Location: ne ct summer,naples in the fall
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
i just spoke with carmen and his dyno was programed to be SAE corrected, he said "its dam close to a dyno jet and might be a tad low"
#44
FormerVendor
iTrader: (51)
Congrats on the #s Barry!!! Thanx for allowing Vengeance to be part of your combo.
I wouldnt get too involved with those doubting Vette Doctors... Carmen has put together WAY TOO MANY cars that RUN the #s as well.... Not to mention Carmen doesnt truly have a dog in this fight. Its an LPE bottom end with the top end being supplied by Vengeance... In all honesty, what would he truly care if it made 450rwhp?? He did his job and did it well, but he has ZERO reason to inflate the #s.
I wouldnt get too involved with those doubting Vette Doctors... Carmen has put together WAY TOO MANY cars that RUN the #s as well.... Not to mention Carmen doesnt truly have a dog in this fight. Its an LPE bottom end with the top end being supplied by Vengeance... In all honesty, what would he truly care if it made 450rwhp?? He did his job and did it well, but he has ZERO reason to inflate the #s.
#45
TECH Enthusiast
Join Date: Apr 2007
Location: Charlotte, NC
Posts: 629
Likes: 0
Received 0 Likes
on
0 Posts
#49
11 Second Club
Join Date: Jun 2005
Location: Was New Orleans, but swam to Baton Rouge
Posts: 1,537
Likes: 0
Received 0 Likes
on
0 Posts
Since I saw this carry over to the dyno section post about 383's I figured I would give it a bump so people can come back and check out the mod list on page 2.