litle88

iTrader: (20)

I'm going to be putting my build back on my car but I know this problem is going to pop up!

How are you guys that have the Ws6 lower airbox and 102mm Tb connecting them? I mean, I'll be going s/d tune but I can't find a place that sells the tubes or anything to join them. Anybody have a site or store to get these from?

Thanks in advance.

Calvertcm2003

iTrader: (1)

http://intakehoses.com although i dont have a Ws6...soo i dont know exactly what u need.

litle88

iTrader: (20)

Thanks alot,

Keep the ideas coming

babbage1109

iTrader: (11)

That's what I was going to say^ just measure the size you need. It's at least a 4 inch for a fast 102 and depending on the lid you're using they have reducers

litle88

iTrader: (20)

It's not so much the measuring, but my lid sits higher and I need something with a bend. I know it sound weird, so I wanted to see what other Ws6 owners have been doing.

30birdy99

iTrader: (14)

Any solution yet?

08 848

iTrader: (3)

Check out www.siliconecouplers.com. They might have the size and bend you need.

jetaws6

iTrader: (3)

I dont know what you mean by lower air box but go to home depot and get what you need from the plumbing section its what I did with mine

WS.666

iTrader: (28)

I used a 4" diameter, 6" long silicone tube from this site with my FAST90 and 98mm FTP lid. I cut the end that connected to the TB angled so it sat flush on the TB and pointed upward towards the lid. Here is a pic of that:



With the 102mm TB, the size is increased to 4.25". To compliment that, I bought a 104mm lid. I also bought a 4.25" diameter, 6" long silicone tube from the same website. Since it worked before, I have no doubt the same strategy will work for me when I finally get my motor.

litle88

iTrader: (20)

Ws6's have a taller lower airbox ( the part where the lid attaches to ) as you can see in the picture above,

jetaws6

iTrader: (3)

Yea I did kinda the same thing WS.666 did with his