QTP Cut-out installed (video)
01-21-2012, 07:25 PM
#1
On The Tree
Thread Starter
iTrader: (2)
Join Date: Nov 2010
Location: Jacksonville, NC
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
QTP Cut-out installed (video) I got my cutout welded up today. If anyone is wondering a good location to put theirs. Here ya go. It is DRONY as hell with the cutout open...but still fun...not too raspy.
http://www.youtube.com/watch?v=UuKZn...PigUCWi9-b1vDb
http://www.youtube.com/watch?v=UuKZn...PigUCWi9-b1vDb
01-21-2012, 07:59 PM
#3
TECH Fanatic
Join Date: Jan 2012
Posts: 1,076
Likes: 0
Received 0 Likes
on
0 Posts
You could get a low profile one... Sets the higher than the pipe. Sounds great man i am wanting to do this to my kooks exhaust. You might wont to bolt some qtp turn downs so the floor board doesnt get hot.
01-21-2012, 10:44 PM
#4
On The Tree
Thread Starter
iTrader: (2)
Join Date: Nov 2010
Location: Jacksonville, NC
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
yeah, its pretty low..it will hit stuff like the rest of my exhaust does. I might change springs to bring the car up a bit when I do QA1's. I might do the turn downs...it is LOUD inside.
