Steam tube/cross over setup question...
On The Tree
Joined: Feb 2016
Posts: 102
Likes: 1
From: Leeuwarden
Man I'm not trying to be a dick but the website you posted, talks about steam pockets. Go there scroll down to the first picture of the radiatorcap that is blue, read the 2 paragraphs below the pic. It's not to far from the top.
No, I did not read the entire site but steam is steam, it rises to the very top, and where is that? I'm thinking right under the steam ports. If you don't want to use them then please don't. It's a stupid idea to want to get the steam out of an engine anyway.
No, I did not read the entire site but steam is steam, it rises to the very top, and where is that? I'm thinking right under the steam ports. If you don't want to use them then please don't. It's a stupid idea to want to get the steam out of an engine anyway.
Thread Starter
TECH Addict
iTrader: (57)
Joined: Aug 2007
Posts: 2,014
Likes: 11
From: Ft. Myers, FL
Update: With sanding approximately 2/3 of the honeycomb off under the LS3 intake I was able to use the 98 4 corner steam tube 
Last edited by ragtopz28; Apr 26, 2016 at 01:11 PM.
I have used gm ones i sell on ebay as in kits for ppl ditching ls1 intake for ls6 or aftermarket. Includes front x-over and 2 rear block offs. Lmk if you want to buy. I sell them on ebay for 39.99 shipped
