Truck Intake cover - fabrication
#1
Truck Intake cover - fabrication
I’m looking to fabricate a cover over my 4.8L Truck intake. A guy off the Chevy 3100 forum made the
one in the picture below which is really nice. He blocked out one of the sides, so only one was functional and added the MAF sensor.
can anyone help me identify where and what MAF sensor I could use? I’d weld the boss in the tube to mount it but a bit lost on what I need.
any other advice on position is welcomed.
thanks!
one in the picture below which is really nice. He blocked out one of the sides, so only one was functional and added the MAF sensor.
can anyone help me identify where and what MAF sensor I could use? I’d weld the boss in the tube to mount it but a bit lost on what I need.
any other advice on position is welcomed.
thanks!
The following users liked this post:
themealonwheels (02-12-2024)